Main Page Sitemap

Uverse hookup diagram


uverse hookup diagram

fresh and new images. I believe that when U-Verse Voice launches, these ports are for that. . For example, my technician installed an 8-port gigabit switch on the other side of the house for connections existing over there. The NID/ONT has an access screw labeled "Customer Access" that grants access to the Customer Wiring side of the NID/ONT. 1) The Ethernet link from the ONT to the Modem requires 2 Cat 5 or higher pairs. They are more or less "Internet devices that tune the iptv streams U-Verse is built around. . Broadband Port: This is, from what I've read, a useless port. . I was electrocuted (it's low voltage but gives u a major sting).

Self-Installation Setup Tips
Hookup Directions for AT T U-verse TV Internet

Coming out of the last slot on splitter is the CAT 5e RG feed, using the orange and green pairs to the. Again, all proper attachments to the house are made. The front of the device has activity lights for local network, USB-PC, Wireless, HomePNA, Phone 1 and Phone 2, as well as lights for Broadband and Service. . It is essentially what a "WAN" port hot local sex dates would be on any other router, which is where an external modem (ie. However, ATT no longer uses green as the defacto DSL wire color. If Buried, the Technician will lay a new Drop from the Pedestal to the house. Disclaimer: The Drop/Service Wire from AT T is the responsibility of AT T, as all Telco Plant elements before reaching the Customer Side of the ONT/NID/Demarc are. Backfeeding on the same CAT 5e RG feed is the VoIP connection, which is then connected to 5 jacks spread throughout house. A cable modem) could be plugged in so the router can "route" the Internet signal. .


Sitemap